How To Clean Water Softener Salt Tank. Remove the salt plate at the bottom of the brine tank. Remove any salt at the bottom of the tank.
If your resin bead is not too discolored, you can simply use a bleach and water solution. Dump water out of the brine tank. Shut off the water to the water softener.
Table of Contents
Dump And Rinse With Water.
Reconnect the brine tubing and drain tubing to the brine tank and add 5 gallons of clean water into the brine tank. Clean out the tank with soap water (dish soap will do the trick), scrubbing the insides of the tank. You can soak it in hot water to help remove salt.
Remove The Brine Valve Chamber By Removing The Screws On The Side Of The Salt Tank.
Your water level should always be slightly lower than your salt level in your water softener brine tank. This may require you to siphon or dump the water. Now, carefully install the resin tank back to the water softener and refill the salt levels before plugging it back.
Clean The Venturi Valve The Venturi Valve And Nozzle Are Needed To Suck The Brine Into The Softening Tank, Where It Replenishes The Resin Bed.
Dump the soapy water and rinse with clean water. Remove the salt plate at the bottom of the brine tank. After that, you need to disconnect the valve of the water softener.
So, You Have To Clean More Often If You Are Using Evaporated Or Any Other Impure Water Softening Salt.
Most water softener resin beads have a lifespan of at least 10 years, though this depends on the quality of the resin, your water usage, and the hardness of your water. However, you can follow the instructions for cleaning the brine tank of your water softener. Empty the remaining salt out of the brine tank.
Wash Out The Area Thoroughly With Water.
How to clean a water softener brine tank: The reason for this is that it will allow enough time for the salt to drop down within the tank to avoid wasting good salt. Remove any salt at the bottom of the tank.