close
close

How To Cover An Unused Light Switch

How To Cover An Unused Light Switch. If you have to leave the circuit energised then you cannot plaster over the light switch and will have to fit a blanking plate. Your question, cover w/ plastic cover vs.

BQLZR 1 Gang Blank Stainless Steel Wall Plate Outlet Cover from www.aliexpress.com

By specifying a brown outlet and cover, the service disappears. If you have to leave the circuit energised then you cannot plaster over the light switch and will have to fit a blanking plate. Once each wire is capped off, then replace the 2 switch plates with 2 solid cover plates.

No Harm In It, And I Don't Think It's A Code Violation.

Any good wallpaper hanger should be able to cover a plate cover in the wallcovering so it simply goes away in the pattern. Adjust the brightness level to be a night light. Your question, cover w/ plastic cover vs.

Identify The Old Furnace Circuit At The Electrical Panel.

If you can trace both ends of the wires, disconnect at both ends and cut the wires outside of all boxes. It can be fun watching people pointlessly flip a switch, too. Fits any standard light switch.

If That's Less Funny To You Than It Is To Me, You May Consider The Blank Cover Plate Someone Else Mentioned.

Whenever someone enters/walks through that room in darkness the night light will turn on for the specified time. It is much easier and quicker than having to patch up the wall, and it allows you the option of being able to use the electrical location in the future. Strip the plastic coating off the ends of the wires.

Prepare The Bare Ends Of The Wires.

#7 · aug 7, 2009. You will need to either find where the wires go and remove them or cover the box with a blank cover. Less of a good idea, but something i have done in the past:

Instead, After Removing The Outlet, Splice The Wires In The Box Together And Cap Them.

I would cap off each black wire, individually, in each box so if some home owner in the future try's to reconnect the circuit and doesn't know the other end blacks are all together he won't end up with a dead short in his face. If the book shelves have a solid back the back must be cut so the cover can be accessed. Carefully bend them back into the box.

Leave a Reply

Your email address will not be published.Required fields are marked *