close
close

How To Light A Water Heater With A Lighter

How To Light A Water Heater With A Lighter. A lighter does not have to be used. Then release it slowly, and make sure the light is still.

DIY How to Relight Your Hot Water Tanks Pilot Light from www.appliancevideo.com

Some water heaters have a red or black igniting button, and others need to be lit manually with a long lighter.when the flame ignites, continue to hold the gas knob or button down for a full minute. Turn the water heat dial to low and the on/off/pilot dial to pilot. Light the pilot and hold the button down for as long as it tells you.

Lighting The Pilot Light On A Manual Hot Water Heater If Your Hot Water Heater Is A Manual, Grab A Long Lighter.

The easiest thing to do is to hold the pilot knob down for 30 seconds, and then to grab the ignition button. You should see a spark. Light the pilot and hold the button down for as long as it tells you.

If On, Continue Pressing The Control Knob For About A Minute To Heat The Thermocouple.

How do you light a self igniting water heater? When the flame ignites, continue to hold the gas knob or button down for a full minute. Step by step instructions for relighting a gas water heater pilot light.

Light The Pilot Continue To Hold The Knob While You Repeatedly Press Or Twist Your Striker Or Lighter Rod (If You Have One), Which Will Create The Spark To Light The Gas.lighting A Water Heater Pilot Light At A Glance.listen For A Click And The Water Heater Status Light Should Start Blinking Ignites;Look On The Side Of Your Hot Water Tank And.

Put all the plates back as they were originally placed. Lighting a water heater pilot light at a glance.look on the side of your hot water tank and read through the procedure that is required for your water heater.now, keeping the knob. While you hold down the gas knob or button, light the pilot light.

This Can Usually Be Done By Lifting It Up.

On gas water heaters, the pilot light makes sure that there’s always flame available when the burner needs to kick in and heat water. While still holding the gas down, light that pilot. If the pilot does not light quick enough the gas valve will shut down and you will have to wait again.

Turn The Water Heaters Gas Valve To The On Position To Ignite The Main Burner.

In other models, there are ignition buttons, usually colored red or black, that when pressed, would create a spark to light pilot light on water heater. Watch through the glass and make sure the pilot stays lit. Lighting a hot water heater pilot light set the temperature control.

Leave a Reply

Your email address will not be published.Required fields are marked *