How To Light Pilot On Richmond Water Heater. A thermocouple is a function on your water heater that senses the heat on the pilot light and allows gas to flow to the burner. Make sure the knob on the feed line is turned to on, then press and hold the ignition button down for 5 seconds and then release.
About 11% of these are equipment indicator lights, 0% are led wall lamps. Ensure that the pilot still remains down and holds the gas. After a few clicks it.
Table of Contents
A Bad Thermocouple Will Shut Off Gas To Both The Pilot And The Burner, Which Is When People Notice That The Water Heater Pilot Light Is Out.
Hold the red button down while pressing the piezo ignitor striker, found to the immediate right of the gas knob, repeatedly until the pilot is lit. With this action, you begin to flow gas toward the flame. Locate the dial first on the side of the water heater, and spin it clockwise to reduce the temperature until it is as low as possible.
While Holding Down The Pilot Gas Valve Or The Red Button With One Hand, You Will Use Your Other Hand To Quickly Light The Pilot.
A day ago i got a call that the water wasn't hot anymore so i went over to check it out. Then switch the button on the heater to the off position. How to light the pilot light on richmond water heaters.
How Long Has This Been Going On?
To turn the water heater pilot light off, set the heater to the lowest temperature possible. And how severe is the problem? This will light the internal pilot light.
Your Water Heater Pilot Light Works In Concert With Other Parts.
Hold the gas knob down when “pilot” is called. Occasionally, the pilot light on your a.o. Ensure that the pilot still remains down and holds the gas.
Pilot Mode Of Some Water Heaters Can Be Found On A Black Or Red Button.
The pilot light turns on, lighting the burner. Push down the red button to the left of the gas knob. Where is the pilot light on a richmond water heater?