close
close

How To Reset Oil Change On Jeep Grand Cherokee

How To Reset Oil Change On Jeep Grand Cherokee. Turn the ignition to the “run” position. Use the navigation button in order to select vehicle info.

Jeep Grand Cherokee 19992004 How to Change Oil from www.cherokeeforum.com

To reset the oil change indicator system (after performing the scheduled maintenance) refer to the following procedure. Basically, you need to use the navigation buttons on the steering wheel to access the menus in the instrument cluster. 2014 jeep grand cherokee oil light reset steps.

Press The Start/Stop Button To Turn The Electronics Off.

Turn the ignition to the “run” position. If necessary repeat this procedure. To reset the 2008 jeep grand cherokee oil change interval, please follow these instructions:to reset the 2017 jeep grand cherokee engine oil life after an oil change service, please follow these instructions:to reset the oil change indicator system (after performing the scheduled maintenance) refer to the following procedure.turn off the.

Hold Down The Ok Button To Reset.

The fastest way to reset oil life and is usually used for all jeep models is by step on the gas pedal three times slowly within 10 seconds after turn the ignition to the run position. Scroll right to reach the oil life screen. Basically, you need to use the navigation buttons on the steering wheel to access the menus in the instrument cluster.

Use The Down Arrow On Your Steering Wheel To Scroll Through The Menu Of Your Vehicle Information Center Until You Reach Vehicle Info.

If the indicator message still illuminates when you start the car, the oil change indicator system did not reset, and you will need to repeat this procedure. Press the ignition start button to run. Ideally after traveling every 5000 miles, you need to perform an oil change (also called service) so the light comes on.

That It Is The Full Procedure How To Reset Oil Service Light Jeep Grand Cherokee.

Without pressing the brake pedal, push the engine start/stop button and cycle the ignition to the on/ run position (do. Cheap insurance to protect your engine. Use the navigation button in order to select vehicle info.

After Fully Depressing The Accelerator Pedal For Three Seconds, The Oil Life Is Reset And The Pedal Is Fully Depressed Again.

Press the start button twice. Turn off the ignition and start the engine to make sure it worked. Now you are going to hold down the ok button until you see that the oil life display has changed to 100 percent.

Leave a Reply

Your email address will not be published.Required fields are marked *