close
close

How To Reset Toyota Corolla Maintenance Light

How To Reset Toyota Corolla Maintenance Light. After it’s off, release the odometer button then start the car. Follow these instructions only after the car has been serviced:

How to reset a maintenance light on a 2016 Toyota Corolla from www.youtube.com

Go to the ⚙️ settings; How do you reset the maintenance light on a toyota corolla? To reset the 2015 toyota corolla s maintenance light put the key in the on position, turn the key off, press and hold the odo/reset button and turn the key back to.

While Holding Down The Trip Meter Reset Knob Turn The Ignition To Run (One Position Before Starting Engine).

If that doesn’t work, try repeating those steps. Turn the ignition to run (one position before starting engine). Turn the key back to “off.”.

Locate And Press And Hold The “Trip Reset” Button On The Odometer.

To reset the 2005 toyota corolla maintenance light, please follow these instructions: This should cause the light to flash, possibly beep, then turn off. How to reset maintenance light 2020 toyota corolla.

Push And Hold The Trip Meter Reset Button On The Dashboard, Then Turn Your Key To The Second Position.

You can do this by turning your vehicle’s ignition off and then pressing the gas pedal once. Keep holding the trip reset button until the miles section of the odometer flashes zero. Depress the odometer button until your dash readout shows trip a.

How To Turn Off Maintenance Light On A Toyota Corolla.

Toyota changed the way you reset the maintenance light again! While pressing the button to reset the trip, turn the key back to the “on” position. If you are driving a toyota corolla, you will need to reset the maintenance light.

This Will Clear The System Of Any Faults, And The Light Should Turn Off.

Usually, the technicians who work on your vehicle will reset the toyota maintenance required light after every service. Then hold odo/trip reset button, then press the “ engine start stop button ” twice or turn ignition on only, don’t release the odo/trip button, until the resetting oil maintenance data or “ 000000 ” is displayed. Go to the ⚙️ settings.

Leave a Reply

Your email address will not be published.Required fields are marked *