close
close

How To Test Honeywell Water Heater Thermostat

How To Test Honeywell Water Heater Thermostat. The first step in this process will be to go get your multimeter. Replace the chamber panel and insulation of the thermostat.

HONEYWELL Low Voltage Thermostat, Stages Cool 2, Stages from www.grainger.com

Cut off the water heater’s power supply. Once the body is off, use a multimeter to test the resistance across the two terminals. First, shut off the breaker that supplies power to the water heater.

Once The Power Is Off, Use A Screwdriver To Remove The Thermostat’s Cover.

Once the body is off, use a multimeter to test the resistance across the two terminals. Find thermostat pros near you. Check the voltage of each thermostat with respect to ground by placing one probe of multi meter on the heating terminals and the other on the body of the water heater.

Read The Terminal No.1 And 3 Carefully, If You See The Figure Of 240V, It.

Go to “up” and “down” buttons to the right of the lcd display on your honeywell thermostat. If you do not get that reading, go and check the power source to. Now that the tools are readily available, it’s time to test the continuity of the thermostats.

Begin By Inspecting The Terminals, Then Search For Any Power Source.

I have a coleman thjd42s41s4 heat pump with a high efficiency gas aux/emergency heater (york tg9s100c16mp11a) and a honeywell th8000 thermostat. Test the thermostats with the multimeter. Start by checking the thermostat terminals for the supply of power.

Test The Water Heater’s Water Temperature Settings.

I’m guessing you already know how the thermostat works as that idea will surely help in this process. Cut off the water heater’s power supply. Steps for testing a water heater with a multimeter.

Its 17 Degrees Outside, The Thermostat Is Set To Heat A.

1 with the power to the furnace off, remove the thermostat or thermostat cover to expose the wires. Reconnect the circuit to its power source by activating the circuit breaker. To check the lower thermostat you need the upper thermostat turned off.use the 1/4 inch nut driver or a flathead screwdriver for this part, ensuring you don’t lose the small screws.use the water heater tester to check terminals #1 and #2 (the lower set).

Leave a Reply

Your email address will not be published.Required fields are marked *